Director 0.33 failing to load

You cannot post here, but its included for searching historical issues

Moderators: aemulor, admin

Locked
jcooke
Posts: 1
Joined: Mon Feb 24, 2003 2:05 am

Director 0.33 failing to load

Post by jcooke » Tue Aug 05, 2003 10:20 pm

Hope I've got the right place for this - I haven't ventured here since registering in February!

!Director (32-bit version) is one of the apps run in my Boot sequence - no problems with Aemulor 2.1, but if Aemulor 2.2 is run from Predesk, Director doesn't appear. I've temporarily stuck Aemulor at the end of the Boot sequence and all seems O.K., but it would be nice to put it back where it was...

JC

admin
Site Admin
Posts: 381
Joined: Wed Oct 23, 2002 11:25 pm
Location: Cambridge, England
Contact:

Post by admin » Fri Aug 08, 2003 5:50 am

Thanks for reporting that... it /is/ a bug in Aemulor - so check the website again soon. It also causes the problems with StrongHelp & Reporter as discussed on the Iyonix support group.

A stupid mistake in my code, sorry.

It shows up when a 32-bit app tries to RMRun a module that has a 'start' entry and there are no parameters supplied in the RMRun command, so it's quite specific & hence I missed it :-(

Switching Aemulor to 'run only if dragged' also corrects the
problem with 2.20.

Adrian

Locked